Hello,
I’ve just purchased the BB60D, mainly for EMC precompliance purposes.
As other forum community told, is there a way to test the Quasi peak measurement in an automatic way? From what I’ve seen, you can tell the device in the “Peak Table” to scan for spuries, but these peaks are much lower than the data calculated in the Meter tab, where the three bars with peak, QP and average are displayed.
Is there a way to press a button and then get QP and AVG waveform be calculated? Also is there a way to display two waveforms, one with QP measurement (or Peak and QP for failing spurs) and another with AVG measurement, each with their own limits?
Thanks,
Mattia Berton
Uploaded Failed |  |