Hello Jared,
Thank you very much for your feedback. There are a couple of points I can address now which might be of help to you.
3) BUG – RBW isn’t entirely settable. In some EMC related ranges I have to settle for 100kHz or 10kHz instead of 120kHz and 9kHz respectively.
Limitations of the device (the SA44/SA124) prevent us from being able to set the RBW to 120kHz. Even our older software was unable to do this, but 9kHz should be available to you at any time during operation.
4) FEATURE – Whilst I only had a brief look at the zero span, AM/FM demodulation, and receiver/channel power etc, the FM demodulation on our local radio stations is much improved and the zero span would give me some useful information, however it would be nice to set this such that it behaves kind of like an oscilloscope (i.e. edge/level triggering and position so I can check duty cycle and Tx power).
In Zero-Span mode, on the control panel you can set a video/external trigger to perform the edge level triggering. Position was added in a subsequent release, so if you download the latest version, you can configure a trigger level and position.
22) FEATURE – Could you get your website guys to put up a changelog file/page or include it in the install files?
Otherwise, it’s a bit vague as to what’s changed between revisions.
I will work on getting the change log on the downloads page. Currently it can be found in the installation folder after you install the software.
Thanks again for the feedback.
Regards,
A.J.
