Reply To: *Warning* : Signal Level Higher Than Ref Level

Hello A.J.

Thank you for the response. I think it was a different poster that was looking to install a USB card.
I have two i7 machines, one does have an installed USB3 PCI express card, and the other machine is newer and has native USB3 support. Both machines are exhibiting the same behavior.

How do I set/reset the reference level in Spike? All the controls on the right hand side of the application are non-responsive. So, I can’t update any of the values.
In the lower right hand side I get the temperature and voltage, both are updating an look to have reasonable values, so I do think I’m communicating with the device.

Should I be able to update the values on the right of the application? When I disconnect from the BB60A then I can update the values on the right hand side, but as soon as I reconnect to the device they jump back to the same values that I’m unable to change.

Do you have any other test or analysis tool application that I can run to help determine where the issue might be?

Thanks,
Ossian