Hi Ivan,
I have some comments on your feedback. The BB60C will rise to operating temperature when the device is connected to the PC via USB, even if the software is not running. If it is possible, you can connect the unit a bit before you plan to use it, allowing the unit to reach full operating temperature. This will eliminate the annoying re-calibrations. Although, I do agree that it would be better to allow the user to re-calibrate it manually.
I believe you can change the div setting without losing the re-calibration currently. I will determine if this is possible with the reference setting as well in the future.
I agree that with more development, calibrations could be handled in a more consistent manner. If you are able to warm up the unit before your measurements I hope this will eliminate most of the issues you have with this.
Thank you for your feedback as always.
Regards,
A.J.
