Forums › General Discussions › Spike Channel Power measurement (all for that matter) › Reply To: Spike Channel Power measurement (all for that matter)
Jared
Participant
Cool – about to install the latest version.
BUG?
On the channel power setup, I have 3 counts, width set to 50k and Spacing set to 100k, however if I set the width to 51k I only see one shaded region…
count, width and spacing are displayed as
fc-spacing +/-width/2,
fc +/-width/2 and
fc+spacing +/-width/2
With these settings I should be able to increase the width right up to ~99k (and have a 2kHz gap between channels).
Do you have a sanity check in there causing this? Should I not be able to run the channel boundaries almost adjacent to each other??
